EARING MADE WITH LED WIRE AND BEADS.

Goodevening pretty lovers of jewerly. I hope that today was so good. Me i was so stressed today because i was helping my step mummy to fry garri in our local house.
Omo i almost forgot to put the earing i am using in order kai. But i just thank God that when i came back from frying the garri, i took my shower and had my dinner, after that i realised that i still have little time left to do this earing so that i can use for my two weeks bible school graduation tomorrow . And since i had the material at home i decided to go ahead and make this beautiful earing with led wire and some beads for tomorrow morning.

I used N/WT 50g Solder core wire.
Orange beads
Pearl beads
Earing hooks
Two big pearl beads

So i first of all cut out the desire length of the led wire that i am going to use.
From there after i bend the edge of one side of the led wire.
I decided to put one big pearl beads first and this big pearl beads will serve as an entrance for the three other entry i am going to be doing.

So after putting the big pearl, i move on to putting one small pearl beads, one orange bead though a bit bigger in size than the pearl bead, and lastly another pearl beads

From putitng the beads i used the edge of the side of the led wire i used in putting the bead to go throuģh the big white bead and then bring it out and try to make it small and round. Now you can see with me the reason why i used the big pearl beads.
Because it has a bigger hole then the smaller one.


The next thing that i did was to put another beads on the second row of the led wire.
I put one pearls beads, one orange bead, one pearl again, one orange and the last one pearl beads.
Then i used the lead wire at the edge to go through that same big pearl beads. I hope you are still seeing my reasons for using the big pearl beads.
After putting the led wire i removed and draged it small small till i had my desire cycle.

So the last row was of three complete orange bead and also four of the pearl beads. Now i had to put it on the led wire one after the other. And then i used the led wire to still go through the pearl bead then i drag it out and arrange the whole thing.

After the third row i decided to cut the wire but not all i remain some so that i can use for coilling.
I crosed it with the first led wire that i kept while i started this earing.

I used one side of the led wire to coll it very well.
An from then i put the earing hooks.
Note that you can also use this earing without the earing hooks because of the way i did the begining part.

Thanks all and goodnight.